View source for M5525 Shure MX202i W/P

==Required Parts And Tools==

* Axis M5525
*:[[File:IMG_7051.JPG|60x80px]]
* RDL STM-1 
*:[[File:STM-1.JPG|60x80px]]
* Shure MX202WP/C Microphone 
*:[[File:MX202WPS-large.jpg|60x80px]]              
* Wire Stripper 
*:[[File:Wire_Stripper_and_Starbit_Driver.JPG|60x80px]]   

* Phillips head drill bit or Phillips head screwdriver
* Small Flat head screwdriver 
*:[[File:Small_Flathead_Screwdriver.JPG|60x80px]]

* Stud Finder

* 22/2 Gauge Wire 
*:[[File:Audio_Cable.JPG|60x80px]]
* Fish Tape or Glow Rod 
*:[[File:15-4-57-m-mid-flex-glow-rod-set-tools-to-k56415-to-k56415-19671-228x228.jpg|60x80px]]
*Wind Screen (Inside MX202i Box) 
*:[[File:Mic_Windscreen.JPG|60x80px]]

==Connecting the STM-==
#Connect MX202WP/C Microphone to the input of the provided wall plate. Connect 22/2 cable to the audio output of that wall plate. VERY IMPORTANT to make the connections AS diagrammed (see below)
#:[[File:202 WP hook up.jpg|400x300px]]
#Connect the output 22/2 cable to the input of the STM-1 (Red to +, Black to -, bare wire to ground). Connect 22/2 wire to the power of the STM-1 (red to + and black to -). Connect the other end of that cable to the IO Connectors on the M5525 labeled 12V and GND (Red to 12V and BLK to GND). Using 22/2 cable, connect the red and black to the HI-Z output (red to + black to -). Connect the other end of that cable to the to the IO Connectors on the M5525 labled Audio IN and GND (red to Audio IN and Black to GND)
#:[[File:STM input and phantom.jpg|400x300px]]
#:[[File:Wired STM 1.jpg|400x300px]]
#:[[File:M5525 connections(1).jpg |400x300px]]
(NOTE; If there are 2 cameras in the room, duplitcate step 9.1.3 using a long enough cable to get to the 2nd camera. If there are 2 Shure MX202i Microphones, duplicate step 9.1.4.)