IVSWikiBlue: Created page with "==Installation Instructions== ===Disassemble the Camera=== #Locate the network drop above the ceiling. It should be terminated with a male Ethernet end (service loop) or a bis..."

2020-05-13T16:27:09Z

Created page with "==Installation Instructions== ===Disassemble the Camera=== #Locate the network drop above the ceiling. It should be terminated with a male Ethernet end (service loop) or a bis..."

New page

==Installation Instructions==
===Disassemble the Camera===
#Locate the network drop above the ceiling. It should be terminated with a male Ethernet end (service loop) or a biscuit jack. This line will have been ran back to the POE switch.
#:''Note:'' If the switch does not have POE, a POE injector will need to be installed at the network closet.
#Using the T20 bit, remove the dome from the P3374/P3375 camera with the T20 security bit.
===Drywall Mounting Instructions===
#Using a stud finder, ensure there aren’t any studs where the camera base will be installed.
#Using a pencil, trace the 2 anchor points on the wall where the screws will be installed and mark the opening where the any cabling will pass through.
#Using a 3/16” drill bit, drill 2 holes at the traced location and insert the plastic anchors.
#Using the hole saw (recommended size 2”), drill a hole into the area where cables will pass through.
#*Ensure the cut hole does not extend past what the camera dome will cover.
#Using the hole saw, drill a hole above the drop ceiling in line with the hole drilled where the camera is mounted.
#*If there is no drywall above the ceiling, adjust accordingly to the circumstance.
#Measure and cut 2 lengths of 22/2 wire long enough to reach the destination where the camera is mounted. One cable will be for audio; the other will be to power the Verifact A. Label both ends of each wire accordingly.
#Using glow rods or fish tape, fish the network drop and 2 sections of 22/2 audio cable down the drywall.
#Mount the Axis P3374/3375 base to the wall using the screws associated with the anchors.
=== Drop Ceiling Inscructions===
#Remove the ceiling tile the camera will be mounted to and determine where on the tile to mount.
#Using a pencil, mark the two holes where the camera base well be attached
#Make a small hole that can be hidden by the camera dome for running cabling through.
#Using toggle bolts, mount the camera.
#Return ceiling tile with mounted camera to drop ceiling.

Template:P3374 Installation Instructions - Revision history

IVSWikiBlue: Created page with "==Installation Instructions== ===Disassemble the Camera=== #Locate the network drop above the ceiling. It should be terminated with a male Ethernet end (service loop) or a bis..."