Difference between revisions of "Mounting Instructions"
IVSWikiBlue (talk | contribs) (Created page with "==Required Parts and Tools== * Epiphan DVI/HDMI Encoder * (4) 1-1/2" corner mounting brackets (mounting screws included) * M3x20 Phillips pan machine screws * SAE #6 flat wa...") |
IVSWikiBlue (talk | contribs) |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 10: | Line 10: | ||
==Installation Instructions== | ==Installation Instructions== | ||
| + | #Determine the mounting location for the encoder. Generally, it will be mounted under a desk or table near the control work station. | ||
| + | #Ensure that the mounting location allows the video cable and Ethernet cables to reach the encoder unit | ||
| + | #Once the location is determined. Measure out the appropriate distance for mounting the four corner brackets | ||
| + | #*3-3/8" between each pair of brackets | ||
| + | #*7" vertically between both pairs | ||
| + | #:[[File:EncoderArmLegnth.JPG|link=https://ipivs.com/wiki/images/3/34/EncoderArmLegnth.JPG]] | ||
| + | #Using a measuring tape and level, mark the four mount post locations | ||
| + | #Using the screws provided with the corner brackets, install the four mount posts | ||
| + | #:[[File:EpiphanCornerBracket.JPG|link=https://ipivs.com/wiki/images/5/55/EpiphanCornerBracket.JPG]] | ||
| + | #Carefully remove the existing screws from the housing of the encoder | ||
| + | #:[[File:EpiphanRemoveScre.JPG|link=https://ipivs.com/wiki/images/1/1f/EpiphanRemoveScre.JPG]] | ||
| + | #Using screws and washers, attach the encoder to the mounting posts | ||
| + | #:[[File:EpiphanMounted.JPG|link=https://ipivs.com/wiki/images/5/50/EpiphanMounted.JPG]] | ||
| + | #Connect the Ethernet cable and respective video cable to the proper connection port. | ||
Latest revision as of 08:49, 8 May 2020
Required Parts and Tools
- Epiphan DVI/HDMI Encoder
- (4) 1-1/2" corner mounting brackets (mounting screws included)
- M3x20 Phillips pan machine screws
- SAE #6 flat washers
- Measuring tape
- Level
- Small screwdriver
- Drill and drill bit
Installation Instructions
- Determine the mounting location for the encoder. Generally, it will be mounted under a desk or table near the control work station.
- Ensure that the mounting location allows the video cable and Ethernet cables to reach the encoder unit
- Once the location is determined. Measure out the appropriate distance for mounting the four corner brackets
- 3-3/8" between each pair of brackets
- 7" vertically between both pairs
- Using a measuring tape and level, mark the four mount post locations
- Using the screws provided with the corner brackets, install the four mount posts
- Carefully remove the existing screws from the housing of the encoder
- Using screws and washers, attach the encoder to the mounting posts
- Connect the Ethernet cable and respective video cable to the proper connection port.
