Difference between revisions of "5525 Wall Mount Instructions"

Revision as of 15:22, 18 August 2020

Locate the AXIS T91E61 Wall Mount.
This is the recommended wall mount by IVS. Verify the model of your mount here.
Locate the AXIS T94A01D Pendant Kit.
Connect the two parts and tighten them together by hand.
Continue tightening, by hand, until you cannot rotate the pendant kit anymore.
Using a T20 bit, tighten down the screw located inside the pendant kit.
Locate the mounting plate.
This part comes packed with the AXIS M5525.
Take the camera disk and line up the 3 pegs on the top with the three holes on the pendant kit.
Put the pegs in the holes and rotate the disk counter clockwise until the pieces prevent you from turning more.
Using a T30 bit, tighten the three screws on top of the pendant kit, securing it to the camera disk.
Take the M5525 and plug the ethernet cable into its respective jack on the camera. The jack will be listed "PoE".
Please not that only cameras prepared by IVS will have the pigtail wire connected to the camera. To learn more click here
Remove the rubber grommets from the base of the camera and run the cables through the holes.

[[File:|350px|link=]]
[[File:|350px|link=]]

@@ Line 22: / Line 22: @@
 #:''Please not that only cameras prepared by IVS will have the pigtail wire connected to the camera. To learn more [https://ipivs.com/wiki/M5525_Pigtail click here]''
 #:[[File:5525CAT6.png|350px|link=https://ipivs.com/wiki/images/5/52/5525CAT6.png]]
-#
+#Remove the rubber grommets from the base of the camera and run the cables through the holes.
-#Take the M5525 and
 #:[[File:Pigtails5525.png|250px|link=https://ipivs.com/wiki/images/1/14/Pigtails5525.png]]
 #:[[File:|350px|link=]]
 #
 #:[[File:|350px|link=]]