Difference between revisions of "Encoder Settings"
IVSWikiBlue (talk | contribs) |
IVSWikiBlue (talk | contribs) |
||
| Line 2: | Line 2: | ||
By default the all Epiphans can always be accessed by the following IP scheme. | By default the all Epiphans can always be accessed by the following IP scheme. | ||
| + | '''''Note: If multiple encoders are on the network, your connection might switch between multiple of the encoders.''''' | ||
* '''IP Address:''' 192.168.255.250 | * '''IP Address:''' 192.168.255.250 | ||
Revision as of 10:45, 31 March 2022
Default IP
By default the all Epiphans can always be accessed by the following IP scheme. Note: If multiple encoders are on the network, your connection might switch between multiple of the encoders.
- IP Address: 192.168.255.250
- Netmask: 255.255.255.252
- User Name: admin
- Password: your admin password (by default set to no password)
Configuring the Encoder
The following camera settings should be enabled prior to adding the camera to the VALT system.
- 1.) Use the Epiphan Discovery Tool to find the VGABroadcaster device.
- 2.) Click on Web Config using the Discovery tool, or enter the <ipaddress>/admin in a web browser to access the configuration menu. The username should be admin, with a blank password. Click on the Access button.
- 3.) Click on the Network button and select Use Static Address, Set the IP, Network Mask, Gateway & DNS information, then click Apply as shown below.
- 4.) Click on the Audio button, change the input source to Mic, and click the Apply button.
- 5.) Click on the Stream tab, scroll to the bottom, change the audio format to AAC 16 kHz, change the bitrate to 96 kbps, and finally click the Apply button.
