Difference between revisions of "Template:P3245LV Disassemble The Camera"
IVSWikiBlue (talk | contribs) (Created page with "===Disassemble the Camera=== #Locate the network drop above the ceiling. It should be terminated with a male Ethernet end (service loop) or a biscuit jack. This line will have...") |
IVSWikiBlue (talk | contribs) (→Disassemble the Camera) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 3: | Line 3: | ||
#:''Note:'' If the switch does not have POE, a POE injector will need to be installed at the network closet. | #:''Note:'' If the switch does not have POE, a POE injector will need to be installed at the network closet. | ||
#Using the T20 bit, remove the dome from the 3245. | #Using the T20 bit, remove the dome from the 3245. | ||
| − | #: | + | #:{{img | file = 3245UnassembledDome.jpg | width=400px}} |
#Remove the camera from the mounting plate. | #Remove the camera from the mounting plate. | ||
| − | #: | + | #:{{img | file = 3245MountPlate.jpg | width=180px}} |
Latest revision as of 08:34, 10 May 2022
Disassemble the Camera
- Locate the network drop above the ceiling. It should be terminated with a male Ethernet end (service loop) or a biscuit jack. This line will have been ran back to the POE switch.
- Note: If the switch does not have POE, a POE injector will need to be installed at the network closet.
- Using the T20 bit, remove the dome from the 3245.
- Remove the camera from the mounting plate.
