Difference between revisions of "Camera Settings 7+"

From IVS Wiki
Jump to: navigation, search
 
(2 intermediate revisions by the same user not shown)
Line 1: Line 1:
 +
{{Article | content =
 
The following camera settings should be enabled prior to adding the camera to the Valt system.
 
The following camera settings should be enabled prior to adding the camera to the Valt system.
  
Line 7: Line 8:
 
[[File:cam_set1.jpg|800px]]
 
[[File:cam_set1.jpg|800px]]
  
3) Click on the stream tab then enable audio using the slider button (ensure audio format is set to AAC) as shown below then press Save.
+
3) Click on the "Stream" tab set the frame rate to "30" then enable audio using the "Include" slider button.
  
 
[[File:cam_set2.jpg|800px]]
 
[[File:cam_set2.jpg|800px]]
  
4) Click on the audio settings section (using chrome) and ensure an signal is present using audio indicator.  When no one is speaking audio should be -40 to -30 db when someone is speaking audio should be -20 to -5 db.
+
4) Click on the "Audio" tab (using chrome) and ensure an signal is present using audio indicator.  When no one is speaking audio should be -40 to -30 db when someone is speaking audio should be -20 to -5 db.
  
 
[[File:cam_set3.jpg|800px]]
 
[[File:cam_set3.jpg|800px]]
  
5) For proper I/O and talkback functionality when using cameras with Axis firmware version 5.70 or greater:
+
5) Click on the "System" tab then click on "Plain config" button as shown below.
 
 
Under Settings --> System Options --> Security --> Users you will need to set Allow password type to Unencrypted only as shown below
 
 
 
After this change you will need to restart the camera.
 
  
 
[[File:cam_set4.jpg|800px]]
 
[[File:cam_set4.jpg|800px]]
  
6)  
+
6) Select "Network" from the drop down then click on "Select group"
  
 
[[File:cam_set5.jpg|800px]]
 
[[File:cam_set5.jpg|800px]]
  
7)
+
7) Select "Basic" from the drop down shown below then scroll to the bottom and click "Save"
  
 
[[File:cam_set6.jpg|800px]]
 
[[File:cam_set6.jpg|800px]]
 +
}}

Latest revision as of 11:17, 10 October 2023

The following camera settings should be enabled prior to adding the camera to the Valt system.

1) Browse to the camera address (you can find the camera address using the Axis IPUtility.exe application) and set the root password.

2) Click on the setup link in the lower right corner.

Cam set1.jpg

3) Click on the "Stream" tab set the frame rate to "30" then enable audio using the "Include" slider button.

Cam set2.jpg

4) Click on the "Audio" tab (using chrome) and ensure an signal is present using audio indicator. When no one is speaking audio should be -40 to -30 db when someone is speaking audio should be -20 to -5 db.

Cam set3.jpg

5) Click on the "System" tab then click on "Plain config" button as shown below.

Cam set4.jpg

6) Select "Network" from the drop down then click on "Select group"

Cam set5.jpg

7) Select "Basic" from the drop down shown below then scroll to the bottom and click "Save"

Cam set6.jpg