Difference between revisions of "Devices and Networking"
IVSWikiBlue (talk | contribs) (Created page with "Device Maintenance Tesira_Device_Maintenance.png File:Tesira_Device_Maintenance.png 1. Network settings 2. Clear configuration 3. Update firmware 4. System ID for Canvas s...") |
IVSWikiBlue (talk | contribs) (→AVB Enable) |
||
| (15 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | Use the following tools to find IP and System settings and Firmware information. | |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | + | ==Device Maintenance== | |
| − | |||
| − | |||
| − | |||
| − | + | {{img | file = Tesira_Device_Maintenance_2.png}} | |
| − | + | #Network settings- click here to set IP's | |
| − | + | #Clear configuration- this will need to be done when sending a brand new config to the device | |
| − | + | #Update firmware. Plan for this to take between 30-60 minutes. Also update the firmware for any remote devices; this will take about 10 minutes for each device | |
| + | #System ID for user interface configuration | ||
| + | |||
| + | ==Device Information== | ||
| + | |||
| + | {{img | file = Tesira_Device_Information_2.png}} | ||
| + | |||
| + | #Check the current firmware version | ||
| + | #System ID for user interface configuration | ||
| + | |||
| + | ==Network Settings== | ||
| + | |||
| + | {{img | file = Tesira_Network_Settings_2.png}} | ||
| + | |||
| + | #Assign IP’s here | ||
| + | #The Control and AVB ports will each have their own IP's. Switch between Control and AVB here | ||
| + | |||
| + | ==AVB Enable== | ||
| + | |||
| + | {{img | file = Tesira_Device_AVB_Enable.png}} | ||
| + | |||
| + | #If using an AVB switch or any ancillary devices, enable AVB here | ||
Latest revision as of 09:04, 10 May 2022
Use the following tools to find IP and System settings and Firmware information.
Device Maintenance
- Network settings- click here to set IP's
- Clear configuration- this will need to be done when sending a brand new config to the device
- Update firmware. Plan for this to take between 30-60 minutes. Also update the firmware for any remote devices; this will take about 10 minutes for each device
- System ID for user interface configuration
Device Information
- Check the current firmware version
- System ID for user interface configuration
Network Settings
- Assign IP’s here
- The Control and AVB ports will each have their own IP's. Switch between Control and AVB here
AVB Enable
- If using an AVB switch or any ancillary devices, enable AVB here
