Difference between revisions of "Template:P3245LV Disassemble The Camera"

From IVS Wiki
Jump to: navigation, search
(Created page with "===Disassemble the Camera=== #Locate the network drop above the ceiling. It should be terminated with a male Ethernet end (service loop) or a biscuit jack. This line will have...")
 
(Disassemble the Camera)
 
(One intermediate revision by the same user not shown)
Line 3: Line 3:
 
#:''Note:'' If the switch does not have POE, a POE injector will need to be installed at the network closet.
 
#:''Note:'' If the switch does not have POE, a POE injector will need to be installed at the network closet.
 
#Using the T20 bit, remove the dome from the 3245.  
 
#Using the T20 bit, remove the dome from the 3245.  
#:[[File:3245UnassembledDome.jpg|link=https://ipivs.com/wiki/images/6/6f/3245UnassembledDome.jpg]]
+
#:{{img | file = 3245UnassembledDome.jpg | width=400px}}
 
#Remove the camera from the mounting plate.  
 
#Remove the camera from the mounting plate.  
#:[[File:3245MountPlate.jpg|link=https://ipivs.com/wiki/images/e/ec/3245MountPlate.jpg]]
+
#:{{img | file = 3245MountPlate.jpg | width=180px}}

Latest revision as of 08:34, 10 May 2022

Disassemble the Camera

  1. Locate the network drop above the ceiling. It should be terminated with a male Ethernet end (service loop) or a biscuit jack. This line will have been ran back to the POE switch.
    Note: If the switch does not have POE, a POE injector will need to be installed at the network closet.
  2. Using the T20 bit, remove the dome from the 3245.
    3245UnassembledDome.jpg
  3. Remove the camera from the mounting plate.
    3245MountPlate.jpg