Difference between revisions of "Tubular LED Key Switch"
IVSWikiBlue (talk | contribs) (Created page with "==Required Parts And Tools== * Securitron KP-1 60x80px * Wire Stripper 60x80px * 1 blank single gang wa...") |
IVSWikiBlue (talk | contribs) |
||
| Line 1: | Line 1: | ||
==Required Parts And Tools== | ==Required Parts And Tools== | ||
| − | * Securitron KP-1 [[File: | + | * Securitron KP-1 [[File:Securitron KP1.JPG|60x80px]] |
* Wire Stripper [[File:Wire_Stripper_and_Starbit_Driver.JPG|60x80px]] | * Wire Stripper [[File:Wire_Stripper_and_Starbit_Driver.JPG|60x80px]] | ||
| − | |||
* Small Flat head screwdriver [[File:Small_Flathead_Screwdriver.JPG|60x80px]] | * Small Flat head screwdriver [[File:Small_Flathead_Screwdriver.JPG|60x80px]] | ||
* B Connectors [[File:BCONN.png|60x80px]] | * B Connectors [[File:BCONN.png|60x80px]] | ||
Revision as of 12:27, 5 January 2017
Required Parts And Tools
- Securitron KP-1
- Wire Stripper
- Small Flat head screwdriver
- B Connectors
- Stud Finder
- 22/4 Solid Gauge Wire
- Fish Tape or Glow Rod
- DryWall Saw
- Mud Ring [[File:Mud_Ring.JPG|60x80px]
Installation Instructions
- Locate the network drop that is ran back to the HIGH POE switch. (If the switch does not have HIGH POE, you will need to insert a HIGH POE injector back at the network closet).
- Remove the P5414/P5415 camera from its base with the starbit security driver. Place the base of the camera on the wall where you’d like to mount. Using a stud finder, ensure there aren’t any studs any behind the camera base. Using a marker or pen, mark the 4 areas on the wall where the screws would be and also mark the opening where the any cabling would come through (Areas labeled on picture).
