Difference between revisions of "Tubular LED Key Switch"

Revision as of 12:54, 5 January 2017

Determine where you want your Securitron Tubular Key Switch to be placed. Use your stud finder to determine that there aren't any studs behind the wall.
Using your drywall saw, cut a rectangle in the drywall large enough to fit the mud ring into securely.
Using your glow rod or fish tape, fish your 22/4 cable up and through the wall and ceiling until you reach the location of your camera.
Strip the jacket off of both ends of the cable revealing the 4 individual strands of cable. Strip those individual cables revealing their solid copper inside.

@@ Line 13: / Line 13: @@
 ==Installation Instructions==
-#Locate the network drop that is ran back to the HIGH POE switch. (If the switch does not have HIGH POE, you will need to insert a HIGH POE injector back at the network closet).
+#Determine where you want your Securitron Tubular Key Switch to be placed. Use your stud finder to determine that there aren't any studs behind the wall.
-#Remove the P5414/P5415 camera from its base with the starbit security driver. Place the base of the camera on the wall where you’d like to mount. Using a stud finder, ensure there aren’t any studs any behind the camera base. Using a marker or pen, mark the 4 areas on the wall where the screws would be and also mark the opening where the any cabling would come through (Areas labeled on picture).
+#Using your drywall saw, cut a rectangle in the drywall large enough to fit the mud ring into securely.
+#Using your glow rod or fish tape, fish your 22/4 cable up and through the wall and ceiling until you reach the location of your camera.
+#Strip the jacket off of both ends of the cable revealing the 4 individual strands of cable. Strip those individual cables revealing their solid copper inside.
 #:[[File:ArrowsOnp5414.JPG|400x300px]]