Difference between revisions of "Recording Sign"
IVSWikiBlue (talk | contribs) |
IVSWikiBlue (talk | contribs) (→Required Parts and Tools) |
||
Line 1: | Line 1: | ||
== Required Parts and Tools == | == Required Parts and Tools == | ||
+ | |||
* VALT Recording Sign | * VALT Recording Sign | ||
− | |||
* Phillips Screw Driver | * Phillips Screw Driver | ||
− | |||
* Wire Stripper | * Wire Stripper | ||
− | |||
* B Connectors | * B Connectors | ||
− | + | * 22/2 Shielded or Unshielded cable | |
− | * 22/2 Shielded or Unshielded | ||
− | |||
* Stud Finder | * Stud Finder | ||
− | * | + | * Hole saw (2") |
* Medium Anchors and Screws | * Medium Anchors and Screws | ||
− | * Fish Tape or | + | * Fish Tape or Glow rods |
− | |||
== Installation == | == Installation == |
Revision as of 14:10, 17 April 2020
Required Parts and Tools
- VALT Recording Sign
- Phillips Screw Driver
- Wire Stripper
- B Connectors
- 22/2 Shielded or Unshielded cable
- Stud Finder
- Hole saw (2")
- Medium Anchors and Screws
- Fish Tape or Glow rods
Installation
- Drill a hole in the sheet rock wall for the 22/2 cable.
- Using fish tape or a wire fish, run 22/2 up through the wall and to the camera.
- Connect the 22/2 to the camera.
- Strip approximately 1 inch of the outer insulation from each end of the 22/2 wire.
- Strip approximately 1/4 inch off the insulation for the black and red conductor on each end of the 22/2 wire.
- Insert the red wire into the number 2 I/O port on the camera. If necessary, trim the wire before inserting to ensure no bare wire is exposed.
- Insert the black wire into the number 4 I/O port on the camera. If necessary, trim the wire before inserting to ensure no bare wire is exposed.
- Drill holes for your anchors and screws and mount the sign.
- Connect the 22/2 to the terminal block inside the VALT Recording Sign.
- Strip approximately 1 inch of the outer insulation from each end of the 22/2 wire.
- Strip approximately 1/2 inch off the insulation for the black and red conductor on each end of the 22/2 wire.
- Use a jewelers flathead screwdriver to tighten the cable into the terminal block; red with red, black with black.
Camera Configuration
Depending on the model of Axis camera, you may need to set the second I/O port on the camera to an output.
- Navigate to the camera's IP address in a web browser
- If prompted, enter the username and password for the camera.
- Click on System; click on Ports
- Ensure that I/O Port 2 is set to Output.