Difference between revisions of "Template:P3245LV Disassemble The Camera"
IVSWikiBlue (talk | contribs) (Created page with "===Disassemble the Camera=== #Locate the network drop above the ceiling. It should be terminated with a male Ethernet end (service loop) or a biscuit jack. This line will have...") |
IVSWikiBlue (talk | contribs) (→Disassemble the Camera) |
||
| Line 3: | Line 3: | ||
#:''Note:'' If the switch does not have POE, a POE injector will need to be installed at the network closet. | #:''Note:'' If the switch does not have POE, a POE injector will need to be installed at the network closet. | ||
#Using the T20 bit, remove the dome from the 3245. | #Using the T20 bit, remove the dome from the 3245. | ||
| − | #:[[File:3245UnassembledDome.jpg|link=https://ipivs.com/wiki/images/6/6f/3245UnassembledDome.jpg]] | + | #:[[File:3245UnassembledDome.jpg|link=https://ipivs.com/wiki/images/6/6f/3245UnassembledDome.jpg|400px]] |
#Remove the camera from the mounting plate. | #Remove the camera from the mounting plate. | ||
| − | #:[[File:3245MountPlate.jpg|link=https://ipivs.com/wiki/images/e/ec/3245MountPlate.jpg]] | + | #:[[File:3245MountPlate.jpg|link=https://ipivs.com/wiki/images/e/ec/3245MountPlate.jpg|180px]] |
Revision as of 07:57, 27 August 2020
Disassemble the Camera
- Locate the network drop above the ceiling. It should be terminated with a male Ethernet end (service loop) or a biscuit jack. This line will have been ran back to the POE switch.
- Note: If the switch does not have POE, a POE injector will need to be installed at the network closet.
- Using the T20 bit, remove the dome from the 3245.
- Remove the camera from the mounting plate.
