Tubular LED Key Switch

Required Parts And Tools

• Securitron KP-1
• Wire Stripper
• 1 blank single gang wall plate
• Small Flat head screwdriver
• B Connectors
• Stud Finder
• 22/4 Solid Gauge Wire
• Fish Tape or Glow Rod
• DryWall Saw
• Mud Ring [[File:Mud_Ring.JPG|60x80px]

Installation Instructions

1. Locate the network drop that is ran back to the HIGH POE switch. (If the switch does not have HIGH POE, you will need to insert a HIGH POE injector back at the network closet).
2. Remove the P5414/P5415 camera from its base with the starbit security driver. Place the base of the camera on the wall where you’d like to mount. Using a stud finder, ensure there aren’t any studs any behind the camera base. Using a marker or pen, mark the 4 areas on the wall where the screws would be and also mark the opening where the any cabling would come through (Areas labeled on picture).