ROAM Manual

Settings

To access the settings page first click the gear icon in the bottom right.

You will be prompted to enter the password before you can access the settings menu. The default password is admin51.

Each of the settings sections can be accessed from the drop menu at the top of the screen.

Application

Settings on this page relate to the overall application.

Application Settings

Password

This setting specifies the password used to access the settings menu.

Orientation

This selects the orientation of the display. It defaults to automatic and will adjust the display based on whether the height or width are greater. It can be forcibly set to Landscape or Portrait mode.

Mode

Selects the operating mode for the application. For ROAM carts, this mode should always be set to Camera Control

Date/Time

Toggles the display of the date and time on or off. Defaults to On.

Buttons

Enabled buttons will be display on the righthand side in Landscape mode or in the status bar at the top of the screen in portrait mode.

Recording Button

Toggles the Recording Controls On or Off. This feature will only function with a VALT server.

Lock Button

Toggles the Room Locking Controls On or Off. This feature will only function with a VALT server.

Comment Button

Toggles the Comment Controls On or Off. This feature will only function with a VALT server.

Camera Control

Settings on this page are specific to the camera control application. These are utilized by the ROAM cart.

Stream Type

The setting allows you to select either an H264 or Motion JPEG stream. The H264 is smaller and contains audio. The MJPG stream is nearer to real time, but does not contain audio. The default should be MJPG for ROAM carts.

Resolution

This setting controls the size of the video stream pulled from the camera. For ROAM carts this should be 800x600.

FPS

This setting controls the frame rate of the video stream. For ROAM carts this should be set to 20 FPS.

Audio

This setting enables or disables video stream audio. It defaults to OFF. Audio will only work if using the H264 stream. For ROAM carts this should be set to OFF.

Keypad

Settings on this page are specific to the keypad application.

Pin Length

This setting allow you to configure the length of the pin code used to start and stop recordings. Each user must be assigned a unique pin code in VALT on this length. The default is 6 digits.

Smart Button