Difference between revisions of "Encoder Settings"
IVSWikiBlue (talk | contribs) |
IVSWikiBlue (talk | contribs) |
||
| Line 1: | Line 1: | ||
The following camera settings should be enabled prior to adding the camera to the Valt system. | The following camera settings should be enabled prior to adding the camera to the Valt system. | ||
| − | 1) Use the Epiphan discovery tool to find the VGABroadcaster device. | + | : 1.) Use the Epiphan discovery tool to find the VGABroadcaster device. |
https://www.epiphan.com/products/vgadvi-broadcaster/vgadvi-broadcaster-downloads/ | https://www.epiphan.com/products/vgadvi-broadcaster/vgadvi-broadcaster-downloads/ | ||
| Line 7: | Line 7: | ||
[[File:ep_1.jpg|400px]] | [[File:ep_1.jpg|400px]] | ||
| − | 2) Click on Web config using the | + | : 2.) Click on '''Web config''' using the Discovery tool, or enter the ''<ipaddress>/admin'' in a web browser to access the configuration menu. The username should be admin with a blank password. Click on the '''Access''' button. |
[[File:ep_2.jpg|800px]] | [[File:ep_2.jpg|800px]] | ||
| − | 3) Click on the | + | : 3.) Click on the '''Network''' button and select ''Use Static Address'', ''Set the IP'', ''Network Mask'', ''Gateway'' & ''DNS'' information, then click '''Apply''' as shown below. |
[[File:ep_3.jpg|800px]] | [[File:ep_3.jpg|800px]] | ||
| − | 4) Click on the | + | : 4.) Click on the '''Audio''' button, change the input source to '''Mic''', and click the '''Apply''' button. |
[[File:ep_4.jpg|800px]] | [[File:ep_4.jpg|800px]] | ||
| − | 5) Click on the | + | : 5.) Click on the '''Stream''' tab, scroll to the bottom, change the audio format to ''AAC 16 kHz'', change the bitrate to ''96 kbps'', and finally click the '''Apply''' button. |
[[File:ep_5.jpg|800px]] | [[File:ep_5.jpg|800px]] | ||
Revision as of 15:12, 26 April 2019
The following camera settings should be enabled prior to adding the camera to the Valt system.
- 1.) Use the Epiphan discovery tool to find the VGABroadcaster device.
https://www.epiphan.com/products/vgadvi-broadcaster/vgadvi-broadcaster-downloads/
- 2.) Click on Web config using the Discovery tool, or enter the <ipaddress>/admin in a web browser to access the configuration menu. The username should be admin with a blank password. Click on the Access button.
- 3.) Click on the Network button and select Use Static Address, Set the IP, Network Mask, Gateway & DNS information, then click Apply as shown below.
- 4.) Click on the Audio button, change the input source to Mic, and click the Apply button.
- 5.) Click on the Stream tab, scroll to the bottom, change the audio format to AAC 16 kHz, change the bitrate to 96 kbps, and finally click the Apply button.
