Difference between revisions of "Video Decoder"

From IVS Wiki
Jump to: navigation, search
(Installation Instructions)
(Decoder Configuration)
Line 42: Line 42:
  
 
==Decoder Configuration==
 
==Decoder Configuration==
You will need to access the Decoder, either over the network or directly from your laptop.  
+
 
 +
The Decoder will need to be accessed, either over the network or directly via a laptop.  
  
 
#) On the Video Sources tab, click '''Add Camera'''.  
 
#) On the Video Sources tab, click '''Add Camera'''.  
 
#) Add the name, IP, username, and password of the cameras one at a time.  
 
#) Add the name, IP, username, and password of the cameras one at a time.  
 
#) On the Display tab, select '''Multiview''' for Multimode, and the appropriate view matrix for View.
 
#) On the Display tab, select '''Multiview''' for Multimode, and the appropriate view matrix for View.

Revision as of 10:15, 21 April 2020

Required Parts And Tools

  • Axis T8705 Unit
  • Anchors and Screws
    Screws and Anchors.JPG
  • Drill bit and drill
    Drill and Brill Bits.JPG
  • Phillips head drill bit or Phillips head screwdriver
  • Cat5/6 Patch Cable (1ft-3ft recommended)
    Cat6 Patch Cable.JPG
  • HDMI cable for customer's monitor (HDMI to DVI or Display Port, if necessary)


Installation Instructions

First, determine whether our customer prefers it to be mounted to the wall behind the monitor, or to the back of the monitor itself

  1. Using a stud finder, ensure there aren’t any studs where the decoder will be mounted. Make a mark where the mount will be screwed to the wall.
  2. Using the drill bit, drill the screw marker and place the anchor inside.
  3. Mount the base to the wall using the screw associated with the anchor. Attach the T8705 to the base.
  4. Plug the HDMI cable into the Decoder, then into the monitor.
  5. Plug the network cable into the Decoder, then into the network jack.
  6. Plug in the power cable for the Decoder.

Camera Configuration

The Cameras' authentication must be set to Encrypted or Digest

  1. ) Navigate to the IP of the camera.
  2. ) (In the old navigation view) Go to Setup in the top right; then System Options.
  3. ) For Allow Password Type, select Encrypted, if it is not already.
    Start stop unencrypt.png
  1. ) (In the new navigation view) Go to Settings; then System; then Plain Config.
    Start stop unencrypt new.png
  2. ) Scroll and select Network.
  3. ) Under HTTP, Authentication Policy should be set to Digest. Scroll to click Save.
    Start stop unencrypt new 2.png


Decoder Configuration

The Decoder will need to be accessed, either over the network or directly via a laptop.

  1. ) On the Video Sources tab, click Add Camera.
  2. ) Add the name, IP, username, and password of the cameras one at a time.
  3. ) On the Display tab, select Multiview for Multimode, and the appropriate view matrix for View.