Difference between revisions of "Template:P3374 Installation Instructions"

From IVS Wiki
Jump to: navigation, search
(Created page with "==Installation Instructions== ===Disassemble the Camera=== #Locate the network drop above the ceiling. It should be terminated with a male Ethernet end (service loop) or a bis...")
 
(No difference)

Latest revision as of 10:27, 13 May 2020

Installation Instructions

Disassemble the Camera

  1. Locate the network drop above the ceiling. It should be terminated with a male Ethernet end (service loop) or a biscuit jack. This line will have been ran back to the POE switch.
    Note: If the switch does not have POE, a POE injector will need to be installed at the network closet.
  2. Using the T20 bit, remove the dome from the P3374/P3375 camera with the T20 security bit.

Drywall Mounting Instructions

  1. Using a stud finder, ensure there aren’t any studs where the camera base will be installed.
  2. Using a pencil, trace the 2 anchor points on the wall where the screws will be installed and mark the opening where the any cabling will pass through.
  3. Using a 3/16” drill bit, drill 2 holes at the traced location and insert the plastic anchors.
  4. Using the hole saw (recommended size 2”), drill a hole into the area where cables will pass through.
    • Ensure the cut hole does not extend past what the camera dome will cover.
  5. Using the hole saw, drill a hole above the drop ceiling in line with the hole drilled where the camera is mounted.
    • If there is no drywall above the ceiling, adjust accordingly to the circumstance.
  6. Measure and cut 2 lengths of 22/2 wire long enough to reach the destination where the camera is mounted. One cable will be for audio; the other will be to power the Verifact A. Label both ends of each wire accordingly.
  7. Using glow rods or fish tape, fish the network drop and 2 sections of 22/2 audio cable down the drywall.
  8. Mount the Axis P3374/3375 base to the wall using the screws associated with the anchors.

Drop Ceiling Inscructions

  1. Remove the ceiling tile the camera will be mounted to and determine where on the tile to mount.
  2. Using a pencil, mark the two holes where the camera base well be attached
  3. Make a small hole that can be hidden by the camera dome for running cabling through.
  4. Using toggle bolts, mount the camera.
  5. Return ceiling tile with mounted camera to drop ceiling.