Pairing Bluetooth Talkback

Perform the following steps to pair the receiver with a Bluetooth® device, such as a mobile phone or tablet.

1. If the Bluetooth unit is powered on, press and hold the power button to turn off the device. The LED on the unit will flash red twice.
2. Wait at least three seconds and then slide the TX/RX switch to the TX position
3. Press and hold the power button to turn the unit back on. The LED will flash blue twice
4. Press the "Pair" button. The LED will begin to rapidly flash blue to indicate the device is paired in TX mode.
5. Power the audio device that will be receiving signal and place it in its Bluetooth pairing mode. The devices will pair and connect within five to thirty seconds and the LED will slowly blink blue when connected