Camera Settings 7

The following camera settings should be enabled prior to adding the camera to the VALT system.

1) Browse to the camera address (you can find the camera address using the Axis IPUtility.exe application) and set the root password.

2) Click on the setup link in the lower right corner.

3) Click on the Stream tab set the frame rate to 30, set the P-frames to 19 and then enable audio using the Include slider button.

4) Click on the Audio tab (using Chrome) and ensure a signal is present, using the audio indicator. When no one is speaking audio should be -40 to -30 db, when someone is speaking audio should be -20 to -5 db.

5) Click on the System tab, then click on Plain config button as shown below.

6) Select Network from the drop-down menu, then click on Select group.

7) Select Basic from the drop-down menu shown below, then scroll to the bottom and click Save.