Encoder Settings

The following camera settings should be enabled prior to adding the camera to the Valt system.

1.) Use the Epiphan discovery tool to find the VGABroadcaster device.

https://www.epiphan.com/products/vgadvi-broadcaster/vgadvi-broadcaster-downloads/

2.) Click on Web Config using the Discovery tool, or enter the <ipaddress>/admin in a web browser to access the configuration menu. The username should be admin with a blank password. Click on the Access button.

3.) Click on the Network button and select Use Static Address, Set the IP, Network Mask, Gateway & DNS information, then click Apply as shown below.

4.) Click on the Audio button, change the input source to Mic, and click the Apply button.

5.) Click on the Stream tab, scroll to the bottom, change the audio format to AAC 16 kHz, change the bitrate to 96 kbps, and finally click the Apply button.