5525 Wall Mount Instructions

1. Locate the AXIS T91E61 Wall Mount.

   This is the recommended wall mount by IVS. Verify the model of your mount here

   

2. Locate the AXIS T94A01D Pendant Kit.

   

3. Connect the two parts and tighten them together by hand.

   

4. Continue tightening, by hand, until you cannot rotate the pendant kit anymore.

   

5. Using a T20 bit, tighten down the screw located inside the pendant kit.

   

6. Locate the mounting plate.

   This part comes packed with the AXIS M5525.

   

7. Take the camera disk and line up the 3 pegs on the top with the three holes on the pendant kit.

   

8. Put the pegs in the holes and rotate the disk counter clockwise until the pieces prevent you from turning more.

   

9. Using a T30 bit, tighten the three screws on top of the pendant kit, securing it to the camera disk.

   

10. Take the M5525 and plug the ethernet cable into its respective jack on the camera.

    Please not that only cameras prepared by IVS will have the pigtail wire connected to the camera. To learn more click here

    The jack will be listed "PoE".

    

12. Take the M5525 and

    

    [[File:|350px|link=]]

13. [[File:|350px|link=]]