Template:P3245LV Disassemble The Camera
Revision as of 09:17, 13 May 2020 by IVSWikiBlue (talk | contribs) (Created page with "===Disassemble the Camera=== #Locate the network drop above the ceiling. It should be terminated with a male Ethernet end (service loop) or a biscuit jack. This line will have...")
Disassemble the Camera
- Locate the network drop above the ceiling. It should be terminated with a male Ethernet end (service loop) or a biscuit jack. This line will have been ran back to the POE switch.
- Note: If the switch does not have POE, a POE injector will need to be installed at the network closet.
- Using the T20 bit, remove the dome from the 3245.
- Remove the camera from the mounting plate.
