Installing Overhead Speaker on Axis Cameras with STM-1

Required Parts And Tools

• Axis P5414-E
• Amplified Overhead Speaker (Any speaker will due, however, we recommend the OWI-AMPR2SIC5 and will be the speaker referenced in these instructions)
• 22/2 audio cable
• Fish Tape or Glow Rod
• Electrical Tape
• Wire Stripper

Installation Instructions

1. Once your camera is installed, locate the AUDIO OUT on your P5414E.
2. Strip the jacket of the 22/2 cable revealing the red, black, and bare wires inside. Cut away the plastic surrounding the cable inside. Strip away a small piece of the red and black jackets revealing the bare copper wire.
3. Wire the black and bare to the - and the red to the + of the AUDIO OUT of the P5414E phoenix connector.
4. In this step, you want to run your 22/2 cable from the camera to your AMP2SIC5, wiring your red wire to the + phoenix connection and black to the - connection of the LINE INPUT of the AMP2SIC5 (See pics).
5. Once audio is plugged in, locate your run 18/2 from the AMP2SIC5 to its designated power outlet. Test the talkback unit is working by activating the talkback function within the Valt Software by having a partner use their computer microphone to communicate with you.