Installing an Axis P3374/P3375 with a Tesira Forte DSP

Required Parts And Tools

Locate the network drop above the ceiling either being a male Ethernet end (service loop) or a biscuit jack. This will have been ran back to the POE switch. If the switch does not have POE, a POE injector will need to be installed at the network closet.
Remove the P3374/P3375 camera from its base with the T20 security bit. Using a stud finder, ensure there aren’t any studs where the camera base will be installed. Using a pencil, trace the 2 anchor points on the wall where the screws will be installed and mark the opening where the any cabling will pass through.
Using a 3/16” drill bit, drill 2 holes at the traced location and insert the plastic anchors. Using the hole saw (recommended size 2”), drill a hole into the area where cables will pass through. Ensure the cut hole does not extend past what the camera dome will cover.
Using the hole saw, drill a hole above the drop ceiling in line with the hole drilled where the camera will be mounted. If there is no drywall above the ceiling, adjust accordingly to the circumstance.
Measure and cut 2 lengths of 22/2 wire long enough to reach the destination where the camera is mounted. One cable will be for audio; the other will be to power the Verifact A. Label both ends of each wire accordingly. Using your glow rod or fish tape, fish the network drop and 2 sections of 22/2 audio cable down the drywall.
Mount the Axis P3374/3375 base to the wall using the screws associated with the anchors.

Select Optional Second Camera

Axis P3235

Axis P3245

Axis P3364/P3365

Axis P3374/P3375

Axis Axis F41

Axis P5414/P5415

Axis Axis M5525

Axis Axis P5635

Axis P5655

Axis V5914/V5915

Axis Q8414