Bluetooth Talkback

Required Parts and Tools

• Monoprice Premium Bluetooth 5 Transmitter & Receiver
• RDL 24V DC power supply
• Single gang mud ring
• Blank single gang face plate
• 22/2 audio cable
• 18/2 low voltage cable
• B Connectors
• Fish Tape or Glow Rods
• Electrical Tape
• Wire Stripper

Installation Instructions

Mounting the Device

1. Determine the location where the Bluetooth transmission device. It will need to be mounted within the reach of its power cable.
   • Note: A USB power block will be needed to connect to a power outlet.
2. Using a stud finder, scan the mounting location of the Bluetooth device is not mounted on a stud.
3. Cut a hole into the drywall, large enough to fit the mud ring into it securely
4. Cut a length of 22/2 long enough to reach from the camera to the Bluetooth device.
5. Using fish tape or glow rods, pass the 22/2 through the drywall.
6. At the camera, connect the 22/2 to the Audio Out port/terminal.
7. Using the face plate that will have the Bluetooth device mounted, measure 3/4" to the right of the top screw hole and drill a hole (3/16") for the 3.5mm cable to pass through.

   

8. Connect the 3.5 to the 22/2 cable using B connectors. Use electrical tape to cover the splice and ensure that the splice occurs on the side of the face plate that will be in the wall.
9. Using a Velcro, attach a 1' square to the back of the device and to the face plate.