Deprecated Page - Installing a VMWare Virtual Appliance

Download the OVF Template

Click on the link below to download the OVF Template for the VALT virtual appliance.
VMWare 6.5: https://ivs.box.com/shared/static/cg9rogxg3yeyf4hg5xxf352lgbjgyhhv.zip

VMWare 7.0: https://ivs.box.com/shared/static/xu4a011h2n4a0dn41rgj6cqooqb9hc6l.zip
Extract the .zip file

Load the Template on vSphere

Open vSphere Client.
Click on File.
Select Deploy OVF Template from the menu.
Click on Browse.
Browse to where you extracted the zip file.
Select the Valt.ovf file.
Click Open.
Click Next.
Click Next.
Enter a name for your VALT appliance.
Click Next.
Select your disk provisioning
Thin Provisioning Recommended
Click Next.
Select the network the appliance should be connected to.
Click Next.
Click Finish.

Configure Virtual Hardware

Right click on the Virtual Machine in vSphere Client.
Select Edit Settings from the menu.
Adjust the memory and CPU of the appliance to support the number of cameras. The table below contains IVS' recommended specs.

Cameras	Cores	Memory
2	2	4 GB
5	4	8 GB
15	8	16 GB
25	16	32 GB
50	32	64 GB

Click OK once all changes have been made.

You can also adjust the size of the data drive. The default size is 2 TB. If you adjust the size of the virtual drive, you will also need to adjust the size of the partition.

Add the USB Key to the VM (Optional)

There are two types of Wowza licenses. By default, IVS will provide a Wowza license key and a USB key. The steps below are to add the USB key to the VM. If you want to use the VM in a highly available environment, IVS can provide a license-only key that does not require a USB key. Please make sure to request this at the time of order.

Right click on the Virtual Machine in vSphere Client.
Select Edit Settings from the menu.
Click Add.
Select USB Controller.
Click Next.
Select EHCI+UHCI.
Click Next.
Click Finish.
Click Add.
Select USB Controller.
Click Next.
Select xHCI.
Click Next.
Click Finish.
Click Add.
Select USB Device.
Click Next.
Select Future Devices HID UNIKEY.
Click Next.
Click Finish.
Click OK.

Configure IP Address

You must complete these steps, even if you have already specified an IP address for the server or want to use DHCP. This will configure the VALT software with the correct IPs

For more in depth information on network configuration options, see the VALT Command Line Menu page.

Access the VALT Server Command Line Menu.
This menu is presented automatically at the VALT server terminal. It can also be accessed via ssh by running the following command from the prompt:

sudo /usr/local/valt/bin/Menu

Enter Option 1 for Network Configuration.
Enter Option 2 for Set IPs.
Select your interface from the options listed.
Select Static or DHCP.
For this example we will select DHCP
Type Y when to configure this interface for client access.
Enter the IP Address of the interface when prompted.

IP Address changes will not take effect until the server has been rebooted.

Set the Timezone

Connect to the VALT appliance via SSH or from the terminal menu, exit to the shell.
From command line type in the following, and press Enter:
```
sudo dpkg-reconfigure tzdata
```
Select your Country.
Select your Time Zone.
From command line type in the following, and press Enter:
```
sudo service apache2 restart
```
From command line type in the following, and press Enter:
```
sudo service WowzaStreamingEngine restart
```