Installing an Axis F41 and Axis F1005 sensor unit with a Louroe Verifact A Microphone

Required Parts And Tools

• Axis F41 Main Unit

  

• Axis F1005

  

• Axis F8001

  

• Louroe IFPX

  

• 3.5mm (Male to Male) Audio Cable
• Louroe Verifact A Microphone

  

• S2 TT10 Torx security bit
• Wire Stripper

  

• Wall Dog Screw Anchors

  

• Toggle Bolts (If mounting to drop ceiling tile)

  

• Drill bit and drill

  

• Phillips head drill bit or Phillips head screwdriver
• Small Flat head screwdriver

  

• Cat5/6 Patch Cable (7ft-15ft recommended)

  

• 22/2 Gauge Wire

  

Installation Instructions

1. Locate the network drop above the ceiling either being a male Ethernet end (service loop) or a biscuit jack. This will have been ran back to the POE switch. If the switch does not have POE, , a POE injector will need to be installed at the network closet.
2. Using the T10 bit, remove the rubber feet from the bottom of the Axis F41 Main Unit, and replace it with the Axis F8001. This will allow the F41 to be mounted to drywall above your drop ceiling.
3. Find the spot where you will be mounting your F41 and IFPX above the drop ceiling. Using four wall dogs (or anchors and screws), mount the F41 and the IFPX into the drywall above your drop ceiling. (Note, if there is no drop ceiling make other arrangements for mounting.)
4. Connect the network drop into the RJ-45 (f) on the IFPX that reads Power+Data In. (You may need an additional patch cable if terminated with an keystone jack) When connected you should see activity on the link lights. If no link lights appear, ensure that POE is enabled on your POE switch and that the network drop is plugged in.
5. Using the CAT5/6 patch cable, connect the camera to the RJ-45 (f) on the IFPX labeled Power+Data Out to the RJ-45 input labeled POE on the Axis F41 Main Unit. When connected, you should see the NET, STATUS, and POWER LEDs light up on the unit. After approximately 1 minute, all 3 should be green. If not, check connections.
6. Take the 3.5mm Male to Male audio cable and connect it from the 3.5mm jack labeled AUDIO OUT on the IFPX, into the AUDIO IN on the Axis F41 Main Unit. (See Picture)

   

7. Assemble the mounting unit for the Axis F1005. Mount the camera into your drop ceiling using toggle bolts. Run the attached RJ-11 cable to the input labeled CAM on the Axis F41 Main Unit. Ensure you drill a hole in the drop ceiling to feed the RJ-11 cable through.

   

Connecting the Microphone

1. Strip the jacket off the 22/2, revealing the red, black, and common (bare wire) on both sides of the cable. Remove the string and plastic casings covering the red and black cables. Strip the red and black jackets off the wire exposing the copper. Cut copper evenly on both ends (See picture)

   

2. Drill a hole into the piece of ceiling tile that you will be mounting the Louroe Verifact-A. Feed one end of the the 22/2 audio cable through the hole. Connect the audio cable to the Verifact-A phoenix terminal as follows; Red to A, Black to B, Common (bare wire) to C (See Picture). Using Toggle bolts, secure the Verifact-A to the drop ceiling tile.

   

   

3. Connect the other end of your 22/2 cable to the terminal on the IFPX labeled MIC/SPEAKER A B C SP. The connections will be as follows: Red to A, Black to B, Common (bare wire) to C (See Picture)