M5525 Shure MX202i W/P

From IVS Wiki
Revision as of 12:39, 22 March 2018 by IVSWikiBlue (talk | contribs) (Connecting the STM-)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Required Parts And Tools

  • Axis M5525
    IMG 7051.JPG
  • RDL STM-1
    STM-1.JPG
  • Shure MX202WP/C Microphone
    MX202WPS-large.jpg
  • Wire Stripper
    Wire Stripper and Starbit Driver.JPG
  • Phillips head drill bit or Phillips head screwdriver
  • Small Flat head screwdriver
    Small Flathead Screwdriver.JPG
  • Stud Finder
  • 22/2 Gauge Wire
    Audio Cable.JPG
  • Fish Tape or Glow Rod
    15-4-57-m-mid-flex-glow-rod-set-tools-to-k56415-to-k56415-19671-228x228.jpg
  • Wind Screen (Inside MX202i Box)
    Mic Windscreen.JPG

Connecting the STM-

  1. Connect MX202WP/C Microphone to the input of the provided wall plate. Connect 22/2 cable to the audio output of that wall plate. VERY IMPORTANT to make the connections AS diagrammed (see below)
    202 WP hook up.jpg
  2. Connect the output 22/2 cable to the input of the STM-1 (Red to +, Black to -, bare wire to ground). Connect 22/2 wire to the power of the STM-1 (red to + and black to -). Connect the other end of that cable to the IO Connectors on the M5525 labeled 12V and GND (Red to 12V and BLK to GND). Using 22/2 cable, connect the red and black to the HI-Z output (red to + black to -). Connect the other end of that cable to the to the IO Connectors on the M5525 labled Audio IN and GND (red to Audio IN and Black to GND). Lastly, connect a small jumper wire from the PWR + on the STM-1 to the PHNTM + on the STM-1. (See diagrams below).
    STM input and phantom.jpg
    Wired STM 1.jpg
    M5525 connections(1).jpg

(NOTE; If there are 2 cameras in the room, duplitcate step 9.1.3 using a long enough cable to get to the 2nd camera. If there are 2 Shure MX202i Microphones, duplicate step 9.1.4.)