Template:3235 Drywall Mounting

From IVS Wiki
Revision as of 16:23, 9 May 2022 by IVSWikiBlue (talk | contribs) (Drywall Mounting Instructions)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Drywall Mounting Instructions

  1. Using a stud finder, scan the mount location to ensure the camera is not mounted on a stud.
  2. Using a pencil, mark the four holes for the mount plate.
  3. Using a 3/16" drill bit, drill the marked locations and
  4. Install anchors and attach the mount plate using screws and washers.
    3245Drywall2.JPG
  5. Using a hole saw or paddle bit, cut a hole centered in the wall plate where cables will pass through.
    3245DrywallHole2.JPG
  6. Using the hole saw, drill a hole above the drop ceiling in line with the hole drilled where the camera is mounted.
  7. Cut two lengths of 22/2 long enough to reach the mounting location of the microphone.
  8. Using glow rods or fish tape, fish the network drop or patch cable in addition to the two sections of 22/2 audio cable through the drywall.
  9. Attach the camera the the mount plate