Installing Overhead Speaker on Axis Cameras with C I/O Connector
Required Parts And Tools
- Axis P5635
- Multicable connector
- Amplified Overhead Speaker (Any speaker will due, however, we recommend the OWI-AMPR2SIC5 and will be the speaker referenced in these instructions)
- 22/2 audio cable
- Fish Tape or Glow Rod
- Electrical Tape
- Wire Stripper
Installation Instructions
- Once your camera is installed, locate the AUDIO OUT on your P5635 Multicable connector.
- Strip the jacket of the 22/2 cable revealing the red, black, and bare wires inside. Cut away the plastic surrounding the cable inside. Strip away a small piece of the red and black jackets revealing the bare copper wire.
- Wire the black and bare to the - and the red to the + of the AUDIO OUT of the P5635 multicable connector.
- In this step, you want to run your 22/2 cable from the camera to your AMP2SIC5, wiring your red wire to the + phoenix connection, black to the - connection, and bare to ground of the LINE INPUT of the AMP2SIC5 (See pics).
- Once audio is plugged in, locate your run 18/2 from the AMP2SIC5 to its designated power outlet. Test the talkback unit is working by activating the talkback function within the Valt Software by having a partner use their computer microphone to communicate with you.
