Installing an Axis P3374/P3375 with a Louroe Verifact A Microphone

Wiring Diagram

Select Optional Second Camera

Axis P3235

Axis P3245

Axis P3364/P3365

Axis P3374/P3375

Axis Axis F41

Axis P5414/P5415

Axis Axis M5525

Axis Axis P5635

Axis P5655

Axis V5914/V5915

Axis Q8414

Locate the network drop above the ceiling. It should be terminated with a male Ethernet end (service loop) or a biscuit jack. This line will have been ran back to the POE switch.
Note: If the switch does not have POE, a POE injector will need to be installed at the network closet.
Using the T20 bit, remove the dome from the P3374/P3375 camera with the T20 security bit.

Using a stud finder, ensure there aren’t any studs where the camera base will be installed.
Using a pencil, trace the 2 anchor points on the wall where the screws will be installed and mark the opening where the any cabling will pass through.
Using a 3/16” drill bit, drill 2 holes at the traced location and insert the plastic anchors.
Using the hole saw (recommended size 2”), drill a hole into the area where cables will pass through.
- Ensure the cut hole does not extend past what the camera dome will cover.
Using the hole saw, drill a hole above the drop ceiling in line with the hole drilled where the camera is mounted.
- If there is no drywall above the ceiling, adjust accordingly to the circumstance.
Measure and cut 2 lengths of 22/2 wire long enough to reach the destination where the camera is mounted. One cable will be for audio; the other will be to power the Verifact A. Label both ends of each wire accordingly.
Using glow rods or fish tape, fish the network drop and 2 sections of 22/2 audio cable down the drywall.
Mount the Axis P3374/3375 base to the wall using the screws associated with the anchors.

Remove the ceiling tile the camera will be mounted to and determine where on the tile to mount.
Using a pencil, mark the two holes where the camera base well be attached
Make a small hole that can be hidden by the camera dome for running cabling through.
Using toggle bolts, mount the camera.
Return ceiling tile with mounted camera to drop ceiling.

Strip the jacket off the 22/2, revealing the red, black, and common (bare wire) on both sides of the cable.
Remove the string and plastic casings covering the red and black cables.
Strip the red and black jackets off the wire exposing the copper. Cut copper evenly on both ends.
- On the cable ran for power, cut off the common (bare wire) completely as it will not be used. (See picture)
Cut a 3.5 mm audio cable in half.
Strip about an inch of the black jacket; then strip about 1/2 inch of red and white strand jacket.
Test the 3.5 cable for polarity (touch one end of the cable tester to the tip of the 3.5 jack and the other end to the red and white wires. This will be the positive wire; the middle section of the 3.5 jack is negative wire; the bottom section of the jack is ground/stranded wire.)
Splice these wires with the camera end of the 22/2 cable ran for audio. Red to A, Black to B, Common (bare wire) to C (See Picture)
Connect the power cable to the IO phoenix connector (Red to 2, Black to 1).
Plug in the network drop to the camera network port, the 3.5 jack into the pink AUDIO IN port on the camera, and the IO Phoenix connector to the IO port.
Also cut a 3” piece of 22/2 cable, but only the inner red wire. Strip ¼” of the jacket from both ends of the cable. Insert and secure this wire as a jumper from Phantom+ to Power+.
Place the dome over on the camera. Using the T20 bit, tighten the dome cover in place.