Monoprice Bluetooth - Installation Instructions

Required Parts and Tools

Determine the location where the Bluetooth transmission device. It will need to be mounted within the reach of its power cable.
- Note: A USB power block will be needed to connect to a power outlet.
Using a stud finder, scan the mounting location of the Bluetooth device is not mounted on a stud.
Cut a hole into the drywall, large enough to fit the mud ring into it securely
Cut a length of 22/2 long enough to reach from the camera to the Bluetooth device.
Using fish tape or glow rods, pass the 22/2 through the drywall.
At the camera, connect the 22/2 to the Audio Out port/terminal.
Using the face plate that will have the Bluetooth device mounted, measure 3/4" to the right of the top screw hole and drill a hole (3/16") for the 3.5mm cable to pass through.
Connect the 3.5 to the 22/2 cable using B connectors. The Left and Right channel from the 3.5 should be connected to the positive side of the 22/2, and the bare wire from the 3.5 should be connected to the ground on the 22/2. Use electrical tape to cover the splice and ensure that the splice occurs on the side of the face plate that will be in the wall.
Using a Velcro, attach a 1" square to the back of the device and to the face plate.