Output Channel Selector Kit

From IVS Wiki
Jump to: navigation, search

Device Data Sheets

Db-rc2st page2.png St-rx2 page2.png

Required Parts and Tools

  • RDL ST-RX2
  • RDL D-RT2ST
  • RDL 24 V power supply
  • Stud finder
  • Fish tape or Glow Rods
  • Drywall Saw
  • Small Screwdriver
  • Face plate screws
  • Shielded Stranded 22/2 + ground Wire
  • (1) terminal block
  • (1) Single Gang mud ring
  • (1) Single gang decorative faceplate
   "Note:" If used with Control Room Audio kit, triple gang mud rings will be used

Mounting the Button

  1. Using a stud finder, scan the mounting location of the DB-RC2ST to ensure the device is not mounted on a stud.
  2. Using a pencil, mark out where the switching button will be located
  3. Cut a hole into the drywall, large enough to fit the mud ring into it securely.
    VerifactDring.JPG
  4. Cut a hole above the drop ceiling to fish lines (if necessary)
  5. Using fish tape or glow rods, pass three lines of 22/2 behind the drywall, two for signal control and one for power. (shown below)
    Db-rc2st wiring.png
  6. Once the lines are ran, mount the selector to the mud ring
  7. Gently secure the face plate once mounted

Wiring the ST-RX2

  1. Determine above the ceiling where the ST-RX2 will be mounted
  2. Connect the lines ran from the DB-RC2ST as shown
    St-RX2 wiring2.png

Note: The ST-RX2 and DB-RC2ST will draw from the same power source and can be connected together using a terminal block

Wiring Diagram

ST-RX2 General Diagram.png