Template:F41 MX202i STM1

From IVS Wiki
Jump to: navigation, search

Connecting the STM-1

  1. Cut a short piece of 22/2 cable (approx. 1 inch). Strip the jacket and from the cable and remove all contents keeping only the red cable. On both ends of the red cable, strip off a piece of the jacket (See picture).
    Phantom Power Jumper.JPG
  2. Connect one end of the 1 inch audio cable to the +PWR terminal and connect the other end into the +PHNTM terminal.
    Phantom PWR STM.JPG
  3. Connect the cable ran for power to both PWR terminals (Red to +, Black to the other terminal) of the STM-1. Connect the other side to the IO phoenix connector (Red to 2, Black to 1).
  4. Connect the cable ran for audio to both LO-Z OUTPUT terminals (Red to +, Black to -, and ground to the ground terminal) of the STM-1. Connect the other end of the 3.5mm cable to the in on the F41. (cut to appropriate length between STM-1 and F41)
    STM1F41.jpeg

Connecting and Mounting the Microphone

  1. Asses the drop ceiling to decide best mounting placement for the MX202i. Avoid tiles adjacent to HVAC or fire safety devices.
  2. Drill a hole into the center of the single gang plate using the ½” paddle bit (if not prefabricated).
  3. Measure center of the drop ceiling tile and drill a similar hole with the ½” paddle bit.
  4. Align the single gang plate to the location of the microphone on the drop ceiling tile using a pair of toggle bolts.
    Plate Mounted to Ceiling.JPG
  5. Run the MX202i through the ½” hole in the ceiling tile and single gang plate with the rubber stopper to secure the microphone in place and plugging the ½” hole .
  6. Adjust the length of the cable of the microphone to a desirable length, hiding the remainder in the ceiling near the STM-1. Attach the windscreen to the MX202i.
    Mx202i.jpg
  7. Run the XLR mini cable to the STM-1 location.
  8. Connect the connect the XLR mini to the 4 pin Male XLR adapter.
  9. Strip away a portion of the red and black cables inside the pigtail, revealing the copper wire inside.
    • The microphone will be connected via the input terminals of the STM-1 (Red to +, Black to -, ground to the ground terminal).
  10. Connect the female XLR to the Male XLR adapter
  11. Connect the other ends of the 22/2 cable to the terminals on F41.
  • The audio line will be connected to a 3.5mm audio cable (cut approx. 12") with B-connectors and inserted in the "Audio In" port
  • Power will be connected to the I/O connector (Black to 1, Red to 2)
F41CompleteWiring.jpg