Difference between revisions of "Output Channel Selector Kit"
IVSWikiBlue (talk | contribs) (Created page with "==Wiring Diagram== ==Required Parts and Tools== *RDL ST-RX2 *RDL D-RT2ST *RDL 24 V * Shielded Stranded 22/2 + ground Wire * (1) Single Gang mud ring or triple gang if paired...") |
IVSWikiBlue (talk | contribs) |
||
| Line 17: | Line 17: | ||
#: [[File:VerifactDring.JPG|link=https://ipivs.com/wiki/images/4/4d/VerifactDring.JPG|170px]] | #: [[File:VerifactDring.JPG|link=https://ipivs.com/wiki/images/4/4d/VerifactDring.JPG|170px]] | ||
#Cut a hole above the drop ceiling to fish lines (if necessary) | #Cut a hole above the drop ceiling to fish lines (if necessary) | ||
| − | #Using fish tape or glow rods, fish 3 lines of 22/2, two for signal control and one for power. | + | #Using fish tape or glow rods, fish 3 lines of 22/2, two for signal control and one for power. (shown below) |
| − | + | [[File:Db-rc2st wiring.png|link=https://ipivs.com/wiki/images/a/ad/Db-rc2st_wiring.png]] | |
| − | |||
==Wiring the ST-RX2== | ==Wiring the ST-RX2== | ||
# | # | ||
Revision as of 10:08, 15 February 2021
Contents
Wiring Diagram
Required Parts and Tools
- RDL ST-RX2
- RDL D-RT2ST
- RDL 24 V
- Shielded Stranded 22/2 + ground Wire
- (1) Single Gang mud ring or triple gang if paired with observation audio kit(s)
- Stud finder
- Fish tape or Glow Rods
- Drywall Saw
- Small Screwdriver
- Face plate screws
Mounting the Button
- Using a stud finder, scan the mounting location of the Verifact D ensure the microphone is not mounted on a stud.
- Using a pencil, mark out where the switching button will be located
- Cut a hole into the drywall, large enough to fit the mud ring into it securely.
-
- Cut a hole above the drop ceiling to fish lines (if necessary)
- Using fish tape or glow rods, fish 3 lines of 22/2, two for signal control and one for power. (shown below)
