Control Room Audio Solution

Description/Objective

In this example, we will be building 1 sim rooms with an overhead speaker and 1 observation room with live audio and a talkback microphone. For physical devices, we will have 1 room microphone, 1 camera, 1 OWISP, and 1 PSP speaker (and/or SHM-1 headphone amp).

Physical Wiring/Line Diagram

We will need 2 inputs and 3 outputs. The inputs and outputs should be as follows:

1. • Input 1: Sim Room Mic
   • Input 2: Control Room Talkback Mic
   • Output 1: Camera in Sim Room
   • Output 2: OWISP in Sim Room
   • Output 3: Control Room Speaker/HP Amp

Tesira Software

Connections

1. Once we've completed our physical connections, open the Tesira software and build a configuration.
2. In this configuration we'll be using the following blocks. Add these blocks to the configuration:
   • TesiraFORTE CI block ("per channel" AEC reference mode)
   • Peak Meter x 3
   • Uber Filter x 2
   • Level Block
   • Compressor with 2 channels, "ganged mode" and "advanced curve"
   • Matrix Mixer with at least 2 inputs and 3 outputs, with 2 extra outputs
3. Connect the blocks as follows:
   • The Tesira Input block will already be connected to the AEC block, so connect the first peak meter to the Input block also. This will help us to be sure we have the proper levels set on the preamp.
   • Connect the AEC block to the Uber Filters.
   • Send the Uber Filters to the Level Block.
   • Send the Level Block to the Compressor and the second peak meter.
   • Send the Compressor to the Matrix Mixer.
   • Connect output 1-3 from the mixer to port 1-3 on the Tesira Output block AND to the third peak meter. This way we can make sure to reach the right audio levels before we send it to the cameras.
   • Connect the 2 extra outputs from the Matrix Mixer to ports 1&2 on the AEC reference.

When we're complete, our file should look something like this:

AEC Block

1. Phantom Power: We will need phantom power on for our mics, and proper levels on the preamps.
2. AEC: For the first time in our example configurations, we are going to use Acoustic Echo Cancellation. The reason for this is: anytime we have a microphone and a talkback speaker in the same room, there is the opportunity for an echo and/or feedback. AEC will help us cancel the delayed audio or feedback. Enable the AEC feature with this button on the AEC Block. We will explore AEC in depth in another section.

Acoustic Echo Cancellation

AEC is important, and sometimes difficult to understand. There is a separate section on how to configure AEC. Click the image below to read up on AEC:

Processing Blocks in Tesira

For further insight about the other processing blocks and settings, refer back to the first configuration example, or click the image below:

EQ and Compression

For information on EQ settings, or click the image below:

For Compression parameters, click the image below: