Difference between revisions of "Infrared (IR) Talkback"
IVSWikiBlue (talk | contribs) (→Installation Instructions) |
IVSWikiBlue (talk | contribs) |
||
| Line 13: | Line 13: | ||
==Installation Instructions== | ==Installation Instructions== | ||
| − | + | ===Connecting to the Camera=== | |
#Once the camera is installed, locate the '''AUDIO OUT''' on your camera | #Once the camera is installed, locate the '''AUDIO OUT''' on your camera | ||
#Strip the jacket of the 22/2 cable revealing the red, black, and bare wires inside. | #Strip the jacket of the 22/2 cable revealing the red, black, and bare wires inside. | ||
#Cut away the bare wire and plastic surround the cable inside. Strip away a small piece of the red and black jackets revealing the bare copper wire. | #Cut away the bare wire and plastic surround the cable inside. Strip away a small piece of the red and black jackets revealing the bare copper wire. | ||
#Wire the black and ground to the - and the red to the + of the AUDIO OUT of phoenix connector. | #Wire the black and ground to the - and the red to the + of the AUDIO OUT of phoenix connector. | ||
| + | ===IR Device mounting Instructions=== | ||
#Run your 22/2 cable to the IR T1. | #Run your 22/2 cable to the IR T1. | ||
#Strip about an inch of white jacket off the 22/2, as well as about 1/2 inch of the colored jackets to expose the wire. | #Strip about an inch of white jacket off the 22/2, as well as about 1/2 inch of the colored jackets to expose the wire. | ||
Revision as of 09:47, 7 May 2020
Contents
Required Parts and Tools
- Williams Talkback System IR T1
- Williams RX224 Receiver
- RDL 24V DC power supply
- 22/2 audio cable
- 18/2 low voltage cable
- B Connectors
- Fish Tape or Glow Rods
- Electrical Tape
- Wire Stripper
Installation Instructions
Connecting to the Camera
- Once the camera is installed, locate the AUDIO OUT on your camera
- Strip the jacket of the 22/2 cable revealing the red, black, and bare wires inside.
- Cut away the bare wire and plastic surround the cable inside. Strip away a small piece of the red and black jackets revealing the bare copper wire.
- Wire the black and ground to the - and the red to the + of the AUDIO OUT of phoenix connector.
IR Device mounting Instructions
- Run your 22/2 cable to the IR T1.
- Strip about an inch of white jacket off the 22/2, as well as about 1/2 inch of the colored jackets to expose the wire.
- Cut a 3.5mm cable open, test for continuity, then splice it with the 22/2 with B-connectors.
- Cover your splice with electrical tape.
- Plug the 3.5 cable into the Line In of the IR T1.
- Once audio is plugged in, locate your nearest power outlet to power the IR T1.
- Note: You may need to use 18/2 cable to add length to the power cable. Ensure that when splicing in the 18/2 to the power, that the red jacket of the 18/2 is spliced into the cable with the dashed white lines on the power supply.
- Ensure your IR T1 and RX224 are set to the same channel.
- Test the talkback unit is working by activating the talkback function within the VALT Software and having a partner to communicate with.
