Difference between revisions of "Output Channel Selector Kit"
IVSWikiBlue (talk | contribs) (→Wiring the ST-RX2) |
IVSWikiBlue (talk | contribs) (→Mounting the Button) |
||
| Line 14: | Line 14: | ||
== Mounting the Button== | == Mounting the Button== | ||
| − | #Using a stud finder, scan the mounting location of the | + | #Using a stud finder, scan the mounting location of the DB-RC2ST to ensure the device is not mounted on a stud. |
#Using a pencil, mark out where the switching button will be located | #Using a pencil, mark out where the switching button will be located | ||
#Cut a hole into the drywall, large enough to fit the mud ring into it securely. | #Cut a hole into the drywall, large enough to fit the mud ring into it securely. | ||
| Line 21: | Line 21: | ||
#Using fish tape or glow rods, fish 3 lines of 22/2, two for signal control and one for power. (shown below) | #Using fish tape or glow rods, fish 3 lines of 22/2, two for signal control and one for power. (shown below) | ||
[[File:Db-rc2st wiring.png|link=https://ipivs.com/wiki/images/a/ad/Db-rc2st_wiring.png]] | [[File:Db-rc2st wiring.png|link=https://ipivs.com/wiki/images/a/ad/Db-rc2st_wiring.png]] | ||
| + | #Once the lines are ran, mount the selector to the mud ring | ||
| + | #Gently secure the face plate once mounted | ||
| + | |||
==Wiring the ST-RX2== | ==Wiring the ST-RX2== | ||
#Determine above the ceiling where the ST-RX2 will be mounted | #Determine above the ceiling where the ST-RX2 will be mounted | ||
Revision as of 10:24, 15 February 2021
Contents
Wiring Diagram
Required Parts and Tools
- RDL ST-RX2
- RDL D-RT2ST
- RDL 24 V power supply
- (1) terminal block
- Shielded Stranded 22/2 + ground Wire
- (1) Single Gang mud ring or triple gang if paired with observation audio kit(s)
- Stud finder
- Fish tape or Glow Rods
- Drywall Saw
- Small Screwdriver
- Face plate screws
Mounting the Button
- Using a stud finder, scan the mounting location of the DB-RC2ST to ensure the device is not mounted on a stud.
- Using a pencil, mark out where the switching button will be located
- Cut a hole into the drywall, large enough to fit the mud ring into it securely.
-
- Cut a hole above the drop ceiling to fish lines (if necessary)
- Using fish tape or glow rods, fish 3 lines of 22/2, two for signal control and one for power. (shown below)
- Once the lines are ran, mount the selector to the mud ring
- Gently secure the face plate once mounted
Wiring the ST-RX2
- Determine above the ceiling where the ST-RX2 will be mounted
- Connect the lines ran from the DB-RC2ST as shown
Note: The ST-RX2 and DB-RC2ST will draw from the same power source and can be connected together using a terminal block
