Output Channel Selector Kit

Wiring Diagram

Required Parts and Tools

• RDL ST-RX2
• RDL D-RT2ST
• RDL 24 V power supply
• Stud finder
• Fish tape or Glow Rods
• Drywall Saw
• Small Screwdriver
• Face plate screws
• Shielded Stranded 22/2 + ground Wire
• (1) terminal block
• (1) Single Gang mud ring
• (1) Single gang decorative faceplate

   "Note:" If used with Control Room Audio kit, triple gang mud rings will be used

Mounting the Button

1. Using a stud finder, scan the mounting location of the DB-RC2ST to ensure the device is not mounted on a stud.
2. Using a pencil, mark out where the switching button will be located
3. Cut a hole into the drywall, large enough to fit the mud ring into it securely.

   

4. Cut a hole above the drop ceiling to fish lines (if necessary)
5. Using fish tape or glow rods, pass three lines of 22/2 behind the drywall, two for signal control and one for power. (shown below)

1. Once the lines are ran, mount the selector to the mud ring
2. Gently secure the face plate once mounted

Wiring the ST-RX2

1. Determine above the ceiling where the ST-RX2 will be mounted
2. Connect the lines ran from the DB-RC2ST as shown

Note: The ST-RX2 and DB-RC2ST will draw from the same power source and can be connected together using a terminal block

Device Data Sheets