Monoprice Bluetooth - Installation Instructions
Revision as of 16:13, 5 January 2023 by IVSWikiBlue (talk | contribs)
Required Parts and Tools
- Monoprice Premium Bluetooth 5 Transmitter & Receiver
- RDL 24V DC power supply
- Single gang mud ring
- Blank single gang face plate
- 22/2 audio cable
- 18/2 low voltage cable
- B Connectors
- Fish Tape or Glow Rods
- Electrical Tape
- Wire Stripper
Mounting the Device
- Determine the location where the Bluetooth transmission device. It will need to be mounted within the reach of its power cable.
- Note: A USB power block will be needed to connect to a power outlet.
- Using a stud finder, scan the mounting location of the Bluetooth device is not mounted on a stud.
- Cut a hole into the drywall, large enough to fit the mud ring into it securely
- Cut a length of 22/2 long enough to reach from the camera to the Bluetooth device.
- Using fish tape or glow rods, pass the 22/2 through the drywall.
- At the camera, connect the 22/2 to the Audio Out port/terminal.
- Using the face plate that will have the Bluetooth device mounted, measure 3/4" to the right of the top screw hole and drill a hole (3/16") for the 3.5mm cable to pass through.
- Connect the 3.5 to the 22/2 cable using B connectors. Use electrical tape to cover the splice and ensure that the splice occurs on the side of the face plate that will be in the wall.
- Using a Velcro, attach a 1" square to the back of the device and to the face plate.
More Information
[[{{{page}}} | ⤺ Back to Main Page]]
