Recording LED

Required Parts and Tools

Cut a hole in the sheet rock wall at the location where the LED indicator will be mounted. The hole should be approximately 2 1/8 inches x 3 5/8 inches.
Insert the mud ring into the hole and tighten it down using the screw driver.

Using fish tape or a wire fish, run 22/2 up through the wall and to the camera.
Strip approximately 2 inches of the outer insulation from each end of the 22/2 wire.
Strip approximately 1 inch off the insulation for the black and red conductor on each end of the 22/2 wire.
Connect the 22/2 to the camera
1. Insert the red wire into the number 2 I/O port on the camera. If necessary, trim the wire before inserting to ensure no bare wire is exposed.
2. Insert the black wire into the number 4 I/O port on the camera. If necessary, trim the wire before inserting to ensure no bare wire is exposed.
Connect the 22/2 to the Valt LED Recording Light Indicator.
1. Splice the red wire to the positive (typically the red wire) on the Valt LED Recording Light Indicator.
2. Splice the black wire to the ground (typically the black wire) on the Valt LED Recording Light Indicator.
Insert both splices into separate B Connectors and crimp the connectors.

Screw the metal faceplate of the Valt LED Recording Light Indicator to the mud ring using the included screws.

Depending on the model of Axis camera, you may need to set the second I/O port on the camera to an output.

Navigate to the camera's IP address in a web browser
If prompted, enter the username and password for the camera.
Click on Setup in the upper right corner.
Click on System Options
Click on Ports & Devices
Ensure that I/O Port 2 is set to Output. If it is not already, change it to output and click save.