Manually Set Up Privacy Switch Rules for 6.x Firmware

If you are complete with the previous page, and you did not use a config file for privacy rules, complete the following steps. In the case of multiple cameras, these steps should only be done for the main camera; the recipient cameras do not need rules built.

Update I/O Ports

1. Open a web browser.
2. Navigate to the IP address of the camera.
3. If prompted, enter the username and password for the camera.
4. Click on Setup in the upper right hand corner of the window.

   

5. Click on System Options.

   

6. Click on Ports & Devices.

   

7. Change I/O Port 2 to Output. For an F41, change I/O Port 4 to Output. For a camera who's ports do not alternate, simply rename the output "Output 2".

   

8. Click Save.