Output Channel Selector Kit

Required Parts and Tools

• RDL ST-RX2
• RDL D-RT2ST
• RDL 24 V power supply
• (1) terminal block
• Shielded Stranded 22/2 + ground Wire
• (1) Single Gang mud ring or triple gang if paired with observation audio kit(s)
• Stud finder
• Fish tape or Glow Rods
• Drywall Saw
• Small Screwdriver
• Face plate screws

Mounting the Button

1. Using a stud finder, scan the mounting location of the Verifact D ensure the microphone is not mounted on a stud.
2. Using a pencil, mark out where the switching button will be located
3. Cut a hole into the drywall, large enough to fit the mud ring into it securely.

   

4. Cut a hole above the drop ceiling to fish lines (if necessary)
5. Using fish tape or glow rods, fish 3 lines of 22/2, two for signal control and one for power. (shown below)

Wiring the ST-RX2

1. Determine above the ceiling where the ST-RX2 will be mounted
2. Connect the lines ran from the DB-RC2ST as shown

Note: The ST-RX2 and DB-RC2ST will draw from the same power source and can be connected together using a terminal block