Difference between revisions of "Speaker Selector Configuration"
IVSWikiBlue (talk | contribs) (→Creating a Canvas User Interface) |
IVSWikiBlue (talk | contribs) (→Creating Presets) |
||
| Line 40: | Line 40: | ||
==Creating Presets== | ==Creating Presets== | ||
| − | + | Open up the mixers, the preset block, and the preset manager on the left side. | |
| − | [[File: | + | [[File:Tesira_Speaker_Selector_Presets.png]] |
| − | |||
| − | |||
| − | |||
==Creating a Canvas User Interface== | ==Creating a Canvas User Interface== | ||
Revision as of 15:27, 1 May 2020
Contents
Description/Objective
This is an example with a Control Room Audio Solution in a nursing sim lab. In this example, there are two speakers in the sim room, however; an OWISP overhead speaker for communication and instructions, and a PSP in-wall speaker to communicate as the dummy patient. The customer is requesting a User Interface to select the speaker for their talkback audio at a moment's notice. This means we will also build a Canvas User Interface (this will be covered in another section). Before building in Canvas, it is crucial to create the Tesira configuration properly.
Physical Wiring/Line Diagram
Below is the physical wiring diagram.
Tesira Software
Connections
- If we've completed our physical connections, open the Tesira software and start building a configuration.
- In this configuration we'll be using the following blocks:
- TesiraFORTE CI block
- Peak Meter x 3
- Uber Filter x 2
- Level Block with 2 ports
- Compressor with "ganged mode" and "advanced curve"
- Matrix Mixer with 2 inputs and 5 outputs
- Standard Mixer with 2 inputs and 2 outputs
- Preset Button with 3 presets
- Connect the blocks as follows:
- Connect a peak meter to the Tesira Input block. This will help us to be sure we have the proper levels set on the preamp.
- Connect the AEC block to the Uber Filters, then the Filters to the Level Block.
- Connect the Level Block to the Compressor and the second Peak Meter.
- Connect the Compressor to the Matrix Mixer.
- Connect outputs 1 & 2 from the Matrix Mixer to the Output block and peak meter.
- Connect output 3 from the Matrix Mixer to the Standard Mixer.
- Connect the outputs from the Standard Mixer to the output block and the peak meter.
- Connect outputs 4 & 5 from the Matrix Mixer to the AEC Reference.
- Place the Preset Block(s) in a convenient place for now.
When we're complete, our file should look something like this:
Creating Presets
Open up the mixers, the preset block, and the preset manager on the left side.
Creating a Canvas User Interface
In another section, we will build the corresponding Canvas UI configuration for the Speaker Selector. Click the image below:
Processing Blocks in Tesira
For further insight about the other processing blocks and settings, refer back to the first configuration example, or click the image below:
EQ and Compression
For information on EQ settings, or click the image below:
For Compression parameters, click the image below:
